MIL-DTL-18045G
TABLE II.
Construction of type I preserver.
Seam
Stch
stch
Stch
No.
Operation
type
type
inch
NOTE: Order of sequences may not
necessarily be in order listed.
1
Cut parts I/A/W applicable
drawings:
A. Inside jacket section.
B. Outside jacket section.
C. Collar section.
D. Slider protection patch.
E. Unicellular foam as required.
2
Cut 2 pieces webbing 3/4 inch wide
301
EFb
8/10
X 2 inches long (turn 1/4 inch X
1/4 inch and hem one end) Weave
D-ring into assembly and stitch to
outer jacket on both sides I/A/W
premarked locations.
3
Cut 2 pieces webbing 1-1/8 inches
301
Efb
8/10
wide X 12 inches long and stitch
1/8 inch from edge and back lock
stitch to outer jacket fronts on
both sides.
4
Cut 2 pieces tie tapes 3/4 inch
301
EFb
8/10
wide X 12 inches long attach to
collar I/A/W designated marks on
both ends of collar.
5
Cut 2-inch width reflective tapes:
A.
4 inches long - 4 each.
B.
12 inches long - 2 each.
C.
3 inches long - 1 each.
D.
7-1/2 inches long - 2 each.
6
Stitch reflective tape to front
301
SSa
8/10
and back of outside jacket sec-
tions I/A/W premarked locations
from drawings - 7 places 3/16
inch on all four sides.
7
Stitch reflective tapes to front of
301
SSa
8/10
collar on outside section I/A/W
premarked locations from drawing -
2 places 3/16 inch on all four
sides.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business