MIL-DTL-18045G
TABLE III.
Construction of type II preserver.
Seam
Operation
Stch
Stch
Stch
No.
type
type
Inch
NOTE:
Order of sequences may not
necessarily be in order
listed.
1
Cut fabric parts I/A/W applicable
drawings:
A. Inside jacket section.
B. Outside jacket section.
C. Chafing patch.
D. Slider protection patch as
required.
2
Cut
2-inch width reflective tape:
A.
4 inches long - 2 each.
B.
12 inches long - 2 each.
C.
3 inches long - 1 each.
D.
7-1/2 inches long - 2 each.
3
Stitch reflective tape to front
301
SSa
8/10
and back of outside jacket section
I/A/W premarked locations from
drawings, seven places, 3/16 inch
on all four sides.
4
Bind slits of outside jacket
301
BSa
section with 3/4 inch width tape.
5
Stitch label to premarked location
301
SSa
8/10
on outside of the inside jacket
section 1/8 inch on all four
sides.
6
Join armholes in and out jacket
sections:
A. With both inside and outside
301
SSa
8/10
sections (inner surfaces to-
gether) stitch 1/2 inch from
edge around perimeter of both
armholes.
B. Open flat 1/2 inch seams and
301
SSad
8/10
stitch 1 inch width tape using
double needle 1/8 inch from
edges.
7
Join shoulder seams:
A. Inner surfaces together join
301
SSa
8/10
both shoulder seams 1/2 inch
from edge.
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business