MIL-L-850E
(4)
Stitch a seam 1/8 inch from the edge around the entire
periphery of the placket.
On this semifinished piece attach two post studs (see
(5)
drawing), stud bodies up, at points (P-3).
(6)
At points (P-4) the socket and plate combinations are
placed, plate sides up, and the socket parts in such a
position that the dot marks are nearest the open end of
the release placket when the assembly is attached to the
left front part of the preserver.
d. Release placket, webbing ; subassembly.
(II)
(1)
A 6 1/2 inch piece of l-inch webbing is folded over on
itself so that the cut ends coincide and stitched along
either side 1/8 inch from the edge.
(2)
A grommet is placed midway from either edge 1 1/2 inches
Two pieces are
from the folded end of the webbing.
needed to complete the subassembly.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection.
Unless otherwise specified
in the contract or purchase order, the contractor is responsible
for the performance of all inspection requirements as specified
herein.
Except as otherwise specified in the contract or
purchase order, the contractor may use his own or any other
facilities suitable or the performance of the inspection
requirements specified herein, unless disapproved by the
Government.
The Government reserves the right to perform
any of the inspections set forth in this specification where such
inspections are deemed necessary to assure supplies and services
conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items shall meet all
requirements of sections 3 and 5. The inspection set forth in
this specification shall become a part of the contractor's
overall inspection system or quality program.
The absence of
any inspection requirements in the specification shall not
relieve the contractor of the responsibility of assuring that all
products or supplies submitted to the Government for acceptance
comply with all requirements of the contract.
Sampling
inspection, as part of manufacturing operations, is an acceptable
practice to ascertain conformance to requirements, however, this
does not authorize submission of known defective material, either
indicated or actual, nor does it commit the Government to accept
defective material.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business