MIL-L-850E
RIGHT FRONT SECTION
Sew part 8 to top of part 2 at (P-8) and (P-9) ; Sew part
(10)
7 around edge of part 2 at the (4) drill holes D-2.
Attach 1-1/8 by 13-1/2 inch tie tape to parts at
(11)
drill hole D-3 with Box X tack.
Tape is to be folded
under 3/4 inch with edge down.
Join 2 pieces part 4 at each end with a 3/4 inches back
(12)
tack, 3/4 inches from fabric edge at (P-10) and (P-n)
for zipper.
Install zipper at opening in part 4.
(13)
Place part 9 over termination of zipper opening to
(14)
create guard over zipper assembly with selvage out.
Attach 1 part 5 at S-2 to part 4 assembly at (P-12).
(15)
Attach other part 5 at opposite end of part 4 assembly.
Sew resulting assembly to parts 2 and 3 at (P-13) around
assembly to (P-14).
Fold top right front in 1 inch, slipping right bottom
(16)
of collar into opening at top of right front,
right front, approximately 1 inch; reinforce with 3 rows
of stitching.
Serge both ends of #30 neck webbing.
(17)
Attach neck webbing to neck using 2 bar tacks at each
(18)
end of collar opening just above edge.
Hem part 6 at 9-inch dimension on one side only (P-15),
(19)
fold in thirds according to drill holes D-4; top stitch
this on three sides. Finished part is approximately 3
by 7 3/4-inches
(20)
Drill holes for sockets 1-1/4 inches from end and
1 inch from finished side of part 6.
Install studs and sockets as required.
(21)
Sew part 8 to top of part 1 at (P-16) and (P-17) ; Sew
(22)
part 7 around edge of part 1 at (4) drill holes D-5.
Attach 1-1/8 by 13 1/2 inches tie tape to parts at
(23)
drill hole D-6 with box X tack with tape folded
3/4 inch under with edge down.
(24)
Sew printed label to part 3 at drill holes D-7.
Sew part 6 placket to part 1 at top; start at (P-18)
(25)
down to (P-16) and across face and up to (P-19).
Join 2 pieces part 4 at each end with a 3/4 inch back
(26)
tack, 3/4-inches from fabric edge at (P-10) and (P-n)
for zipper.
Install zipper at opening in part 4.
(27)
(28)
Place part 9 over termination of zipper opening to
create guard over zipper assembly with selvage edge out.
(29)
Attach 1 part 5 at S-2 to part 4 assembly at (P-12).
Attach other part 5 at opposite end of part 4 assembly.
Sew resulting assembly to part 1 and 3 at (P-20) around
assembly to (P-21).
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business