MIL-D-87030B(SH)
Procedure
3.6.19 Procedure for joining assembled neck pieces to suit.
for joining assembled neck pieces to suit shall be as follows:
(a) Apply cement to the bottom edge of the assembled neck piece and
neck opening.
(b) Abut and press firmly together, according to guides, so that a
smooth bond and fit is achieved between the two assemblies.
The seams of the assembly shall be even and flush.
3.6.20 Checking of cemented seams.
(a) Cemented seams shall be checked inside and outside for proper
cementing.
(b) Touch up with cement all seams inside and outside.
Procedure for
3.6.21 Procedure for attaching reinforcement pieces .
attaching reinforcement pieces shall be as follows:
(a) Apply cement to the front reinforcement, back reinforcement,
reinforcement strip and suit.
(b) Secure reinforcement to inside of suit.
(c) The positioning of the reinforcement pieces shall be as follows:
Front reinforcement piece. Position on inside with the "Y"
(1)
shaped end down facing the crotch seam. The reinforcement
.
piece shall begin by overlapping the "V" of the front
pieces , continuing down the front seam onto the side body
.
and leg, until reaching the groin joining seams.
Back reinforcement piece. Position on inside with the "T"
(2)
shaped end down facing the seat seam. The reinforcement
piece shall begin by overlapping the "V" of the back piece,
continuing down onto the side body and leg until reaching
the groin joining seams.
Reinforcement strip. Position on inside between and
(3)
abutting the front and back reinforcement pieces along
the crotch and seat seam.
3.6.22 Procedure for attaching fusible seal tape for finish appearance.
Procedure for attaching fusible seal tape for finish appearance shall be as
follows: Seams , except that portion covered by reinforcement pieces on the
inside of the suit, shall be covered by seal tape. The seal tape shall finish
smooth without wrinkles or ridges. The tape shall be centered over the seam.
Ends of seal tape shall overlap each other approximately 1/2 inch.
(a) Apply seal tape to all seams on inside of suit.
Procedure for attaching
3.6.23 Procedure for attaching size numbers.
size numbers shall be as follows:
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business