MIL-S-53120
4.3.2 Tests. Upon successful completion of the examination specified in 4.3.1,
the first article shall be subjected to the tests marked "X" in column 1 of
table 1. Failure of any test shall be cause for rejection.
4.4
Quality conformance inspection.
4.4.1 Samplinq. Sampling for examination shall be in accordance with
MIL-STD-105, inspection level II.
4.4.2 Examination. Samples selected in accordance with 4.4.1 shall be examined
for defects listed in 4.5.1. Presence of one or more defects shall be cause for
rejection.
4.4.3 Tests. Samples selected in accordance with 4.4.1 shall be subjected to
the tests marked "X" in column 2 of table 1. Failure of any test shall be cause
for rejection.
4.5
Inspection schedule.
4.5.1
Examination.
The SDASS shall be examined for the following defects:
101.
Components and equipment missing or not as specified (see 3.1).
Material(s) not as specified (see 3.3).
102.
Materials not resistant to corrosion and deterioration, or treated to be
103.
resistant to corrosion and deterioration of the applicable storage and
operating environments (see 3.3.1).
104.
Dissimilar metals as defined in MIL-STD-889 are not effectively insulated
from each other (see 3.3.2).
Used, rebuilt or remanufactured components, pieces, or parts incorporated
105.
in the compressor (see 3.3.3).
Cadmium plating used (see 3.3.4).
106.
107.
Safety not as specified (see 3.6).
108.
Human factors engineering not as specified (see 3.7).
109.
Component anchorage or storage not as specified (see 3.8).
110.
Identification marking not as specified (see 3.9.1).
Instruction plates not as specified (see 3.9.2).
111.
Treatment and painting not as specified (see 3.10).
112.
113.
Workmanship not as specified (see 3.12).
114.
Fabrication not as specified (see 3.12.1).
115.
Cleaning procedure and cleaning not as specified (see 3.12.2 and applicable
drawings).
116.
Riveted connections not as specified (see 3.12.3).
Welders and welding not as specified (see 3.12.4 and 3.12.5).
117.
Welders' certification not available, not as specified (see 3.12.4).
118.
119.
Any part or component not in accordance with the requirements as shown on
the drawings.
120.
Any dimensions, other than those identified by the QAP requirements, shown
on the drawings, not as specified.
121.
Assembly not complete or not correct (see applicable drawing).
122.
Rivets or other fasteners missing (see applicable drawing).
123.
Parts or components misidentified or dislocated (see applicable drawing).
9
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business