MIL-PRF-25369D
the solicitation. Unless otherwise specified, the documents not listed in the DoDISS are the issues
of the documents cited in the solicitation (see 6.2).
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)/AMERICAN SOCIETY FOR
QUALITY (ASQ)
ANSI/ASQ Z1.4
-
Sampling Procedures and Tables for Inspection by
Attributes (DoD-adopted)
(Application for copies should be addressed to American Society for Quality, P.O. Box 3066,
Milwaukee, WI 53201-3066, or to the American National Standards Institute, 11 West 42nd
Street, 13th Floor, New York, NY 10036.)
2.3
Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been
obtained.
3.
REQUIREMENTS
3.1
First Article. When specified (see 6.2), a sample shall be subjected to first article
inspection in accordance with 4.2.
3.2
Materials. All materials shall be of the corrosion-resistant type, suitably treated to resist
corrosion due to salt spray or any other atmospheric condition likely to be met in storage or
normal service. See 3.2.1 if any type of plating or coating is to be used to protect against
corrosion.
3.2.1 Material limits for coated or plated threads. When externally threaded parts are to be
coated or plated, the minimum pitch diameter may be reduced by an amount equal to 0.3 times the
pitch diameter tolerance but not more than 0.0015 inch. All external thread elements shall be
within the adjusted tolerance before coating. The limits for coated or plated threads shall be the
same as required for uncoated or unplated threads.
3.3
Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible provided that
the material meets or exceeds the operational and maintenance requirements, and promotes
economically advantageous life cycle cost.
3.4
Gas charge. Filled cylinders shall contain non-medicinal carbon dioxide that shall conform
to table I:
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business